Flügger Wall Primer Pro – Special grundmaling

Application

Brush, roller or sprayer
Match tool selection with finish requirements
Apply wet on wet and finish by stroking/rolling in the same direction
Always use the same batch number on continuous/unbroken surfaces
Differences in surface structure can result in shade deviation Cold/heat can affect the viscosity of the material
Material temperature when spraying min 12⁰C
Condensation during drying/curing must not occur
Cold and increased humidity prolong drying time, cure through and re-treatment interval Increased temperature and low humidity reduce drying time and through curing Always carry out trial treatment to check and accept adhesion and result

Treatment

Loose material and paint are removed by cleaning and sanding. Dirt, grime, grease and contagious material are removed with Fluren 37. Water-soluble discolouration, nicotine and soot are cleaned with Fluren 49 and treated with Iso Primer. Hard, smooth surfaces are matt sanded and primed as necessary with Fix Primer. Cracks, unevenness and holes are puttyed. New or bare cleaned wood is primed with Stop Primer. Apply 1-2 times. Some colors require additional treatments.

Technical data

Dilution Water. When spraying, dilute if necessary. 5-10%

Drying time

Dust dry at 20°C, 60% RH: 1 hour Retreatment dry at 20°C, 60% RH: 8 Hours Fully cured at 20°C, 60% RH: 28 Days

Environment

Remove as much paint as possible from tools before washing in water. Do not pour leftover liquid paint down the drain, hand it in at the local recycling station. Minimize your paint waste by calculating in advance how much will be used. Store excess paint correctly so that leftovers can be used, thus minimizing environmental impact.

Range capability

8 m2/litre